Darrin’s Burson V6 Classic Opamp with Music Hall dac25.3

Published on

Post Info

Initial impressions are the presentation is more open and clean across the frequency spectrum. The slight change in mid focus from lower to higher range, but overall more detailed. The bottom end is slightly lighter but more accurate. Top-end has opened up quite a lot with more depth and detail. It has enhanced the Totems party trick, which is a huge soundstage. The system now fills the room at any volume.

The System

Listening with

Music Hall dac25.3 · DAC with tube (6922) single-ended output and headphone amp · discontinued
  • Frequency response: 2 Hz – 20 kHz (±0.2 dB)
  • Output impedance: 0.3 Ω (headphone)
  • Output voltage: RCA 2.0 V · XLR 2.0 V (single “output level” figure published)
  • Inputs: coaxial; optical; AES/EBU (XLR); USB (24/96)
  • Outputs: RCA (tube); XLR (solid-state balanced); 6.35 mm headphone (4 V max, 0.3 Ω)
  • DAC / chipset: TI / Burr-Brown PCM1796; TI SRC4192 ASRC (96 / 192 kHz upsampling)
  • Other: THD+N <0.04% tube / <0.0015% balanced (1 kHz); SNR >110 dB; dynamic range >120 dB (24-bit); crosstalk <-110 dB; <30 W

[1] [2]

Burson

Burson V6 Classic Opamp

Specs from manufacturer data unless a source below says otherwise. “calc.” values are worked out from those figures (V = √(P × R); 110 dB SPL used as a loud reference level). Gear listed without specs is not in our spec library yet.

  1. Music Hall dac25.3: manualslib.com
  2. Music Hall dac25.3: theturntablestore.com