David Burson Super Charger 3A with ZMF VC, Focal Clear and ZMF Aeolus

David’s Burson Super Charger 3A with ZMF VC, Focal Clear and ZMF Aeolus

Published on

Post Info

Great service and very helpful!

The System

Listening with

ZMF Verite Closed · Headphones: closed-back, dynamic (vapor-deposited beryllium), circumaural
  • Impedance: 300 Ω
  • Sensitivity: ~99 dB/mW (approx., “~” as published)
  • Frequency response: not published
  • Plugs / cables supplied: not published (ZMF lists no connector type)

[1]

Focal Clear · Headphones: open-back, dynamic (40 mm Al/Mg M-dome), circumaural · discontinued
  • Impedance: 55 Ω
  • Sensitivity: 104 dB SPL / 1 mW @ 1 kHz ≈ 116.6 dB/V (calc.)
  • Frequency response: 5 Hz – 28 kHz
  • Plugs / cables supplied: 4-pin XLR; 6.35 mm; 3.5 mm cables supplied

[2] [3] [4]

ZMF Aeolus · Headphones: open-back, dynamic (TPE), circumaural · discontinued
  • Impedance: 300 Ω
  • Sensitivity: ~97 dB/mW (approx., “~” as published)
  • Frequency response: not published
  • Plugs / cables supplied: not published (ZMF lists no connector type)
  • Other: weight 445 g

[5]

Burson

Burson Super Charger 3A · Power supply (24 V DC)
  • Other: 24 V / 3 A; noise floor <1 µV; 2.5 mm barrel plug, centre positive; 100-240 V AC in

[6] [7]

Also in the system

Holo Audio Spring 3 · DAC: discrete R2R ladder DAC with native DSD (optional preamp module, Level 1/2/KTE editions)
  • Output impedance: 27 Ω (RCA); 54 Ω (XLR)
  • Output voltage: RCA 2.9 V (PCM) / 1.45 V (DSD128) · XLR 5.8 V (PCM) / 2.9 V (DSD128)
  • Inputs: USB (isolated; PCM to 1.536 MHz, DSD1024 native); I2S; coaxial; optical; AES
  • Outputs: RCA; XLR (preamp module optional: 5.8 / 11.6 V)
  • DAC / chipset: discrete R2R (no DAC chip)
  • Other: PCM 48 kHz NOS: THD+N 0.00032%, DNR 127 dB; 40 W

[8]

RME ADI-2 DAC · DAC / headphone amp (FS version)
  • Frequency response: 0 Hz – 20.2 kHz (-0.1 dB @ 44.1 kHz) … 0 – 115 kHz (-1 dB @ 384 kHz)
  • Output power (headphone): 16 Ω 0.94 W · 32 Ω 1.2 W
  • Output impedance: XLR 200 Ω; RCA 100 Ω; phones 0.1 Ω
  • Output voltage: RCA 6 dB below XLR (-5 to +13 dBu; +13 dBu ≈ 3.5 V, calc) · XLR switchable +19/+13/+7/+1 dBu @ 0 dBFS (+19 dBu ≈ 6.9 V, calc)
  • Gain: phones High Power +22 dBu (10 V) into >=100 Ω / Low Power +7 dBu (1.73 V); IEM output -3 dBu (0.55 V)
  • Inputs: USB; SPDIF coax (RCA, AES-compatible); SPDIF optical (ADAT-compatible)
  • Outputs: XLR; RCA; 6.3 mm phones; 3.5 mm IEM
  • DAC / chipset: not published
  • Other: SNR XLR 120 dB unw / 123 dBA; THD <-120 dB; phones max 1.5 W/ch @ 0.001% THD; 32 Ω figure is 1.2 W @ +18 dBu, 16 Ω 0.94 W @ +14 dBu (test points, not max)

[9]