Toni Burson V5 Opamp with Creative Sound Blaster ZxR

Toni’s Burson V5 Opamp with Creative Sound Blaster ZxR

Published on

Post Info

Dear Burson Audio, My Name Toni from Indonesia. Last week i just ordered 2 x V5 Dual and 2 X V5 Single from one of Burson Audio retailer in Indonesia, Starlite Harmoni. I’m going to upgrade stock op amp on my lovely sound card Sound Blaster ZXR with V5 op amp. I really excited with the sound after upgrade to V5, great job Burson Audio!!

The System

Listening with

Creative Sound Blaster ZxR · Sound card: PCIe sound card + DBpro daughterboard + Audio Control Module · discontinued
  • Output impedance: not published
  • Output voltage: RCA not published
  • Gain: not published
  • Inputs: line in 2x RCA (DBpro); Toslink in; 6.35 mm mic
  • Outputs: amplified 6.35 mm headphone; 2x RCA; 2x 3.5 mm (rear, C/sub); Toslink out
  • DAC / chipset: not published
  • Other: SNR 124 dB; Sound Core3D; up to 24-bit/192 kHz; “600 Ω headphone amplifier”; swappable op-amps

[1]

Burson

Burson V5 Opamp · Discrete opamp (single / dual) · discontinued
  • Supply voltage: ±3.5 V to ±15 V (absolute maximum)
  • Gain-bandwidth product: 50 MHz (at 100 kHz)
  • Dual or single: dual and single (this post uses the dual and the single)
  • Package: 14.5 mm wide × 12.4 mm deep × 29 mm high (V5-OPA-D)

[2]

Specs from manufacturer data unless a source below says otherwise. “calc.” values are worked out from those figures (V = √(P × R); 110 dB SPL used as a loud reference level). Gear listed without specs is not in our spec library yet.

  1. Creative Sound Blaster ZxR: archived page (web.archive.org)
  2. Burson V5 Opamp datasheet V1.1